Job Details

Overview:

A JAB Recruitment client is seeking Stack Pad Pipe Fitter in West Little York areas, Houston, TX. This is for a temp role for 6-month for day shift. The role is responsible to Fabricate, Bend, Install, Assemble, Repair, and Maintain Piping Hydraulic systems.

Main duties & responsibilities:

• Pull, push, or pry steel components into approximate position while member is supported by hoisting device.
• Force components into final position, using crowbars, jacks and hand tools.
• Verify vertical and horizontal alignment of components using cutting torch.
• Cut steel components to make alterations using cutting torch.
• May repair products by dismantling, straightening, reshaping, and reassembling parts using cutting torch and tools.
• Lay out, fabricate, assemble and install piping and piping systems.
• Plan and coordinate daily work with limited supervision.
• Perform other work-related tasks as assigned.
• Comply with all Company and HSE policies and procedures.

Facility/Group Specific Responsibilities:

• Ability to follow leads direction with little supervision.
• Plan layout and installation in accordance with instruction or work requirement schematics.
• Work at elevated heights
• Operate man lift, scissor lift, and overhead crane.
• Understand common practices for instrument fitter.
• Work in fast pace, always changing environment.
• Shall be able to measure, cut, bend and fit-up various sizes of stainless-steel piping 1", 1-1/2", and 2"
• Shall be able to layout full scale drawing of piping systems.
• Shall be able to read and interpret assembly and hydraulic drawings.
• Shall be able to maintain and operate hydraulic tabletop bender.
• Shall be able to layout pipe runs and pipe support brackets in accordance with procedures.
• Shall be able to layout, position, align, and secure sub-assemblies using a level, straight edges, combination squares, plum bobs, and measuring tape.

Job Requirements:

• Will be standing, sitting and walking throughout the workday.
• Work in a non-climate control environment.

Education & Experience Qualifications:

• High School Diploma or GED.
• 3 or more years related experience.
• Read and interpret assemble/hydraulic drawings.

Behavioral Competencies:

• Informing.
• Learning on the fly.
• Technical Learning.
• Time Management.